1. Standardized fixture frame made by metal which is easy to change;

2. Needle plate: non-metallic acrylic sheet, anti-static, FR4, G10 etc., implanted test pins by high-speed CNC drilling machine.
3. Bearing: for precise alignment and easy installation of the needle bed.
4. Spring: it holds up the flowing board to balance UUT, the equilibrium pressure of each test needle in the needle bed.
5. Floating board:as a buffer board placed UUT, size and hole position is determined by the UUT, carved machining, optional anti-static material.
6. Pressure bar:as the proper installation location, press and hold the UUT, allowed to equilibrate contact test pins, the material is PVC or anti-static material.
7. guide shaft: for guiding needle bed precise alignment.

8. Partition: Pressure bar installed on the spacer effect is to minimize the vibrate during pressing down.
9. Top board: connecting the needle bed, installed at the machine.
10. Socket board: installation of ICT or FCT cable.
11. Column: supporting the needle bed.
12. The guide shaft: floating plate for guiding the UUT.
13. Socket board: installation of ICT or FCT cable.
14. Balance column (rubber stopper): Glue stick installed in the relative position on the role of the pressure test points balance the UUT.
15. The column stopper: to support the pressure on the needle plate to make sure needle plate is not deformed ensure balance.

 
Needle bed design principles:
1. Let UUT to balance a variety of external pressure, to ensure that no deformation.
2. The test can accurately rolling pin on a test point to ensure good contact!